Sam joined two identical bulbs, P and Q, in parallel to a battery, each on its own branch. Bulb Q lit, but bulb P did not.
- Give two different possible reasons why bulb P did not light. [2]
- Sam swapped the two bulbs, so that bulb P was on Q's branch and bulb Q was on P's branch. Now the bulb on Q's branch lit, but the bulb on P's branch did not. What can Sam conclude? Explain. [1]
Need a hint?
(b) After the swap, which bulb is lit? What does that tell you about bulb P itself?
Model answer
- (a) Bulb Q lights, so the battery works; the problem is only on P's branch.
- The gap could be the bulb itself (fused) or the branch (a loose wire or bad contact).
- (b) P lit on Q's branch, so P works; Q did not light on P's branch, so the branch has the fault.
(a) Bulb P may be fused. A wire on P's branch may be loose or broken (or P is not screwed in properly), leaving a gap in that branch.
(b) The fault is in P's branch, not in bulb P: bulb P lit when it was moved to Q's branch, so it works, and the bulb that worked before (Q) did not light on P's branch.
How the 3 marks are given
- (a) Gives one reason: bulb P is fused / faulty.
- (a) Gives a second, different reason: a loose / broken wire or poor contact on P's branch (e.g. P not screwed in properly), leaving a gap there.
- (b) Concludes that the fault is in P's branch (wire / holder), not in bulb P, because P lit on Q's branch and Q did not light on P's branch.
One mark for each point. Keywords count: an everyday word in place of the science word can lose the mark.
The mistake this question tests
Concluded more than the results show
In (b), "bulb P is fused" is ruled out by the result: P lit when it was moved. A working bulb (Q) did not light on P's branch, so the gap must be in that branch: a loose or broken wire, or a bad holder.
More PSLE Science electrical systems questions
A battery lights three bulbs, X, Y and Z, joined in a way that Ravi cannot see
See the answer →MCQ · 2mLin touched the two clips of a working circuit tester to a dry paper towel, 2 cm apart, and the bulb did not…
See the answer →Open-ended · 2mLim joined 1, 2, 3 and then 4 identical bulbs to a new battery, each bulb on its own branch, in parallel
See the answer →MCQ · 2mThe number display above a hawker stall uses seven light bars for each digit
See the answer →MCQ · 2mA door alarm uses a switch made of two thin, springy strips sealed in a glass tube, with a small gap between…
See the answer →Open-ended · 3mJia is building a bedside light with one battery, one switch, S, and three identical bulbs
See the answer →Practise PSLE Science until the mistakes stop.
Three PSLE questions, free, no sign-up. You’ll see exactly where the marks went. Then 7 days of everything for S$4.99.